Re: GNAT & Tasking

[T.Cornah@shef.ac.uk (A J Cornah)]

I finished a correspondence some time last week about the shortcomings of the 
current scheduler under MS-DOS (stop reading now if you are not using DOS). It 
has disappeared from my news articles list but to sum up:
  jerry@jvdsys.nextjk.stuyts.nl informed me that DELAY " ... should put the 
task to sleep, however in the current DOS version it does not do this ..."
and went on " ... A next DOS version should definitely include this capability 
... "
  dewar@merv.cs.nyu.edu stated that "ACT has dropped support for DOS and has 
no plans to develop a release past the 3.07 one"

I hope this helps even if in a negative way.

tony

In article <34590FF0.251D9DC9@camberabq.com>, paladino@camberabq.com says...
>
>Hello,
>
>I am trying to multi-task with GNAT but I have the following problem.
>
>I have one task looping from the Realtime clock and I want another task
>to
>receive information from ethernet at the same time.  If I loop on the
>realtime clock then the ethernet code does not run.  If I comment out
>the
>realtime clock then the ethernet code runs.
>
>Any Ideas?
>
>Richard Paladino
>Camber Corporation
>Flight Simulation Division
>5550 Midway Park Place NE
>Albuquerque, NM 87109
>Ph: (505)345-9959
>Fax: (505)343-0766
>www.camber.com
>
>