Pango Font Size

Pango Font Size

[ldries46]

I am trying to put anscreen image also to the printer.

For the cairo parts within the image it was easy. I just measured the image 
on the screen then send the image to a PDF Printer and measured it on screen 
in the 100% PDF image. That resulted in the factor I needed. But using the 
same factor with the Pango parts did nothing to the Font Size.

I used a Size 48 for the screen That gave me a good character size
The Cairo  factor  I calculated was 8 So I expected to need 384 for 
myharacter size. With Set_Size The Character completely disappeared
With Set_Absolute Size The size on the screen stayed the same And on the 
printer it stayed aldo the same bu about a factor 8 to small.

What routine should I use to to Set the corret size for my fonts on both the 
printer and the screen

L. Dries